Kontron AT8404 CLI - Manual (Page 344)

AT8404 FASTPATH log messages
Page B - 11 AT8404 CLI Reference Manual
Table 26: IPv6 Provisioning Log Message
Component Message Cause
IPV6 Provisioning ipv6ProvIntfIsConfigurable: Error accessing
IPv6 Provisioning config data for interface %d
A default configuration does not exist for this
interface. Typically a case when a new
interface is created and has no pre-
configuration.
Table 27: MFDB Log Message
Component Message Cause
MFDB mfdbTreeEntryUpdate: entry does not exist Trying to update a non existing entry
Table 28: 802.1Q Log Messages
Component Message Cause
802.1Q dot1qIssueCmd: Unable to send message %d
to dot1qMsgQueue for vlan %d - %d msgs in
queue
dot1qMsgQueue is full.
802.1Q dot1qVlanCreateProcess: Attempt to create a
vlan with an invalid vlan id %d ;
VLAN %d not in range,
This accommodates for reserved vlan ids. i.e.
4094 - x
802.1Q dot1qMapIntfIsConfigurable: Error
accessing DOT1Q config data for
interface %d in
dot1qMapIntfIsConfigurable.
A default configuration does not exist for this
interface. Typically a case when a new
interface is created and has no pre-
configuration.
802.1Q dot1qVlanDeleteProcess: Deleting the default
VLAN
Typically encountered during clear Vlan and
clear config
802.1Q dot1qVlanMemberSetModify,
dot1qVlanTaggedMemberSetModify:
Dynamic entry %d can only be modified after it
is converted to static
If this vlan is a learnt via GVRP then we cannot
modify it’s member set via management.
Table 29: 802.1S Log Messages
Component Message Cause
802.1S dot1sIssueCmd: Dot1s Msg Queue is
full!!!!Event: %u, on interface: %u, for
instance: %u
The message Queue is full.
802.1S dot1sStateMachineRxBpdu(): Rcvd BPDU
Discarded
The current conditions, like port is not enabled
or we are currently not finished processing
another BPDU on the same interface, does
not allow us to process this BPDU
802.1S dot1sBpduTransmit(): could not get a buffer Out of system buffers