Kontron AT8404 CLI - Manual (Page 327)

AT8404 Management Commands
Page 5 - 51 AT8404 CLI Reference Manual
5.16.12 show boardinfo clock amc
This command shows the configuration of the AMC clocks. The AMC clocks are displayed with the source (from
carrier or AMC), state (enabled/disabled) and (if enabled) the internal clock index with clock configuration attributes.
If the source is the AMC, it is checked whether a AMC is present (otherwise state is set to ‘not present’). For source
AMC the AMC is queried with the get clock state command and if the IPMI command is not supported the state is
set to ‘--’. For source Carrier the clock state is queried from the local on-carrier device where the AMC clock is
connected to.
Format show boardinfo clock amc
Mode Priviledged EXEC