Kontron AT8404 CLI - Manual (Page 219)

AT8404 Utility Commands
Page 4 - 5 AT8404 CLI Reference Manual
4.3.5.1 no ekeying all (configure)
This command disables the ekeying for all ports for which ekeying is possible.
4.4 System Information and Statistics Commands
This section describes the commands you use to view information about system features, components, and
configurations.
4.4.1 show arp switch
This command displays the contents of the IP stack’s Address Resolution Protocol (ARP) table. The IP stack only
learns ARP entries associated with the management interfaces - network or service ports. ARP entries associated
with routing interfaces are not listed.
4.4.2 show eventlog
This command displays the event log, which contains error messages from the system. The event log is not cleared
on a system reset.
Format no ekeying all
Mode Global Config
Format show arp switch
Mode Privileged EXEC
Term Definition
IP Address IP address of the management interface or another device on the management network.
MAC Address Hardware MAC address of that device.
Interface For a service port the output is Management. For a network port, the output is the slot/port of
the physical interface.
Format show eventlog
Mode Privileged EXEC
Term Definition
File The file in which the event originated.
Line The line number of the event.
Task Id The task ID of the event.
Code The event code.
Time The time this event occurred.
Note: Event log information is retained across a switch reset.