Kontron AT8404 CLI - Manual (Page 301)

AT8404 Management Commands
Page 5 - 25 AT8404 CLI Reference Manual
5.8.12 snmp-server enable traps stpmode
This command enables the sending of new root traps and topology change notification traps.
5.8.12.1 no snmp-server enable traps stpmode
This command disables the sending of new root traps and topology change notification traps.
5.8.13 snmptrap
This command adds an SNMP trap receiver. The maximum length of is 16 case-sensitive alphanumeric
characters. The is the version of SNMP. The version parameter options are snmpv1 or snmpv2.
The SNMP trap address can be set using both an IPv4 address format as well as an IPv6 global address format.
The notification argument specifies the type (trap or inform request) for generating traps. The default is ‘trap’. The
‘inform request’ is only possible for version 2c. This is implicitely set by specifying ‘inform request’.
Example: The following shows an example of the CLI command.
(admin #) snmptrap mytrap ip6addr 3099::2
5.8.13.1 no snmptrap
This command deletes trap receivers for a community.
Default enabled
Format snmp-server enable traps stpmode
Mode Global Config
Format no snmp-server enable traps stpmode
Mode Global Config
Note: The parameter does not need to be unique, however; the and pair
must be unique. Multiple entries can exist with the same , as long as they are associated with a
different . The reverse scenario is also acceptable. The is the community name used
when sending the trap to the receiver, but the is not directly associated with the SNMP
Community Table, See “snmp-server community” on page 5 - 21.
Format snmptrap ipaddr
snmptrap ipaddr snmpversion {snmpv1 | snmpv2}
snmptrap ipaddr notification {trap | inform}
Mode Global Config
Format no snmptrap
Mode Global Config