Kontron AT8404 CLI - Manual (Page 53)

AT8404 Switching Commands
Page 2 - 17 AT8404 CLI Reference Manual
2.2.25 show spanning-tree interface
This command displays the settings and parameters for a specific switch port within the common and internal
spanning tree. The > is the desired switch port. The following details are displayed on execution of the
command.
2.2.26 show spanning-tree mst port detailed
This command displays the detailed settings and parameters for a specific switch port within a particular multiple
spanning tree instance. The parameter is a number that corresponds to the desired existing multiple
spanning tree instance. The > is the desired switch port.
Bridge Max Age Configured value.
Bridge Max Hops Bridge max-hops count for the device.
Bridge Hello Time Configured value.
Bridge Forward
Delay
Configured value.
Bridge Hold Time Minimum time between transmission of Configuration Bridge Protocol Data Units (BPDUs).
Format show spanning-tree interface
Mode • Privileged EXEC
• User EXEC
Term Definition
Hello Time Admin hello time for this port.
Port Mode Enabled or disabled.
BPDU Filter Enabled or disabled.
BPDU Flood Enabled or disabled.
BPDU Guard Enabled or disabled.
Root Guard Enabled or disabled.
Port Up Time Since
Counters Last
Cleared
Time since port was reset, displayed in days, hours, minutes, and seconds.
STP BPDUs
Transmitted
Spanning Tree Protocol Bridge Protocol Data Units sent.
STP BPDUs
Received
Spanning Tree Protocol Bridge Protocol Data Units received.
RST BPDUs
Transmitted
Rapid Spanning Tree Protocol Bridge Protocol Data Units sent.
RST BPDUs
Received
Rapid Spanning Tree Protocol Bridge Protocol Data Units received.
MSTP BPDUs
Transmitted
Multiple Spanning Tree Protocol Bridge Protocol Data Units sent.
MSTP BPDUs
Received
Multiple Spanning Tree Protocol Bridge Protocol Data Units received.
Format show spanning-tree mst port detailed
Term Definition