Kontron AT8404 CLI - Manual (Page 284)

Management Commands AT8404
AT8404 CLI Reference Manual Page 5 - 8
sets the outbound Telnet operational mode as ‘linemode’ where, by default, the operational mode is ‘character
mode’. The noecho option disables local echo.
5.3.3 transport input telnet
This command regulates new Telnet sessions. If enabled, new Telnet sessions can be established until there are
no more sessions available. An established session remains active until the session is ended or an abnormal
network error ends the session.
5.3.3.1 no transport input telnet
Use this command to prevent new Telnet sessions from being established.
5.3.4 transport output telnet
This command regulates new outbound Telnet connections. If enabled, new outbound Telnet sessions can be
established until the system reaches the maximum number of simultaneous outbound Telnet sessions allowed. An
established session remains active until the session is ended or an abnormal network error ends it.
5.3.4.1 no transport output telnet
Use this command to prevent new outbound Telnet connection from being established.
Format telnet [debug] [line] [noecho]
Modes • Privileged EXEC
• User EXEC
Note: If the Telnet Server Admin Mode is disabled, Telnet sessions cannot be established. Use the ip
telnet server enable command to enable Telnet Server Admin Mode.
Default enabled
Format transport input telnet
Mode Line Config
Format no transport input telnet
Mode Line Config
Default enabled
Format transport output telnet
Mode Line Config
Format no transport output telnet
Mode Line Config