Kontron AT8404 CLI - Manual (Page 141)

AT8404 Switching Commands
Page 2 - 105 AT8404 CLI Reference Manual
2.20.5 set mld maxresponse
Use this command to set the MLD Maximum Response time for the system, on a particular interface or VLAN. The
Maximum Response time is the amount of time in seconds that a switch will wait after sending a query on an
interface because it did not receive a report for a particular group in that interface. This value must be less than the
MLD Query Interval time value. The range is 1 to 65 seconds.
2.20.5.1 no set mld maxresponse
Use this command to set the max response time (on the interface or VLAN) to the default value.
2.20.6 set mld mcrtexpiretime
Use this command to set the Multicast Router Present Expiration time. The time is set for the system, on a particular
interface or VLAN. This is the amount of time in seconds that a switch waits for a query to be received on an interface
before the interface is removed from the list of interfaces with multicast routers attached. The range is 0 to 3600
seconds. A value of 0 indicates an infinite timeout, i.e. no expiration.
2.20.6.1 no set mld mcrtexpiretime
Use this command to set the Multicast Router Present Expiration time to 0. The time is set for the system, on a
particular interface or a VLAN.
2.20.7 set mld mrouter
Use this command to configure the VLAN ID for the VLAN that has the multicast router attached mode enabled.
Default 10 seconds
Format set mld maxresponse <1-65>
Mode • Global Config
• Interface Config
• VLAN Mode
Format no set mld maxresponse
Mode • Global Config
• Interface Config
• VLAN Mode
Default 0
Format set mld mcrtexpiretime <0-3600>
Mode • Global Config
• Interface Config
Format no set mld mcrtexpiretime
Mode • Global Config
• Interface Config
Format set mld mrouter
Mode Interface Config