Kontron AT8404 CLI - Manual (Page 278)

Management Commands AT8404
AT8404 CLI Reference Manual Page 5 - 2
5. Management Commands
This chapter describes the management commands available in the FASTPATH CLI.
The Management Commands chapter contains the following sections:
• 5.1 “Network Interface Commands” on page 5 - 2.
• 5.2 “Console Port Access Commands” on page 5 - 5.
• 5.3 “Telnet Commands” on page 5 - 7.
• 5.4 “Secure Shell (SSH) Commands” on page 5 - 11.
• 5.5 “Management Security Commands” on page 5 - 13.
• 5.6 “Access Commands” on page 5 - 14.
• 5.7 “User Account Commands” on page 5 - 15.
• 5.8 “SNMP Commands” on page 5 - 20.
• 5.9 “RADIUS Commands” on page 5 - 32.
• 5.10 “TACACS+ Commands” on page 5 - 42.
• 5.11 “Configuration Scripting Commands” on page 5 - 45.
• 5.12 “Pre-login Banner and System Prompt Commands” on page 5 - 47.
• 5.13 “Diagnostics Commands” on page 5 - 47
• 5.14 “PCI express Commands” on page 5 - 47
• 5.15 “Storage Commands” on page 5 - 48
• 5.16 “Clock support commands” on page 5 - 48
5.1 Network Interface Commands
This section describes the commands you use to configure a logical interface for management access. To configure
the management VLAN, see 2.3.2 “network mgmt_vlan” on page 2 - 21
5.1.1 enable (Privileged EXEC access)
This command gives you access to the Privileged EXEC mode. From the Privileged EXEC mode, you can configure
the network interface.
5.1.2 serviceport ip
This command sets the IP address, the netmask and the gateway of the network management port.
Caution! The commands in this chapter are in one of three functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every configuration
command, there is a show command that displays the configuration setting.
• Clear commands clear some or all of the settings to factory defaults.
Format enable
Mode User EXEC
Format serviceport ip [gateway]