Kontron AT8404 CLI - Manual (Page 61)

AT8404 Switching Commands
Page 2 - 25 AT8404 CLI Reference Manual
2.3.13 vlan port tagging all
This command configures the tagging behavior for all interfaces in a VLAN to enabled. If tagging is enabled, traffic
is transmitted as tagged frames. If tagging is disabled, traffic is transmitted as untagged frames. The ID is a valid
VLAN identification number.
2.3.13.1 no vlan port tagging all
This command configures the tagging behavior for all interfaces in a VLAN to disabled. If tagging is disabled, traffic
is transmitted as untagged frames. The ID is a valid VLAN identification number.
2.3.14 vlan protocol group
This command adds protocol-based VLAN groups to the system. The <groupName> is a character string of 1 to 16
characters. When it is created, the protocol group will be assigned a unique number that will be used to identify the
group in subsequent commands.
2.3.15 vlan protocol group add protocol
This command adds the to the protocol-based VLAN identified by . A group may have
more than one protocol associated with it. Each interface and protocol combination can only be associated with one
group. If adding a protocol to a group causes any conflicts with interfaces currently associated with the group, this
command fails and the protocol is not added to the group. The possible values for protocol are ip, arp, and ipx.
2.3.15.1 no vlan protocol group add protocol
This command removes the <protocol> from this protocol-based VLAN group that is identified by this
<groupid>. The possible values for protocol are ip, arp, and ipx.
Format vlan port tagging all <1-4094>
Mode Global Config
Format no vlan port tagging all
Mode Global Config
Format vlan protocol group
Mode Global Config
Note: FASTPATH software supports IPv4 protocol-based VLANs.
Default none
Format vlan protocol group add protocol
Mode Global Config
Format no vlan protocol group add protocol
Mode Global Config