Kontron AT8404 CLI - Manual (Page 306)

Management Commands AT8404
AT8404 CLI Reference Manual Page 5 - 30
5.8.25.1 no set board snmp site
This command resets the sites used to monitor IPMI information via SNMP.
5.8.26 show boardinfo snmp site
This command displays the sites used to monitor IPMI information via SNMP. The sites are indicated by ‘local’ for
the local site and by the IPMB address for remote sites..
5.8.27 set board snmp ipmi-trap
This command enables/disables the generation of IPMI traps. If enabled, IPMI traps are sent if no filter (see below)
exists or one filter rule fits..
5.8.28 set board snmp ipmi-trap interval
This command specified the monitoring interval in seconds. The IPMI SEL is read and checked for generation of
IPMI traps after each interval. The default is 30 seconds..
5.8.29 set board snmp ipmi-trap filter
This command specified filter rules. It is checked for each SEL entry whether a specified rule fits. In this case a IPMI
trap is sent. 20 rules can be specified..
5.8.29.1 no set board snmp ipmi-trap filter
This command resets filter rules.
Mode Privileged Exec
Format no set board snmp site {local | }
Mode Privileged Exec
Format show boardinfo snmp site
Mode Privileged Exec
Format set board snmp ipmi-trap {enable | disable}
Mode Privileged Exec
Format set board snmp ipmi-trap interval <1..600>
Mode Privileged Exec
Format set board snmp ipmi-trap filter <1..20>
Mode Privileged Exec
Format no set board snmp ipmi-trap filter <1..20>
Mode Privileged Exec