Kontron AT8404 CLI - Manual (Page 255)

AT8404 Utility Commands
Page 4 - 41 AT8404 CLI Reference Manual
4.8.16 ip dhcp excluded-address
This command specifies the IP addresses that a DHCP server should not assign to DHCP clients. Low-address and
high-address are valid IP addresses; each made up of four decimal bytes ranging from 0 to 255. IP address
0.0.0.0 is invalid.
4.8.16.1 no ip dhcp excluded-address
This command removes the excluded IP addresses for a DHCP client. Low-address and high-address are valid IP
addresses; each made up of four decimal bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid.
4.8.17 ip dhcp ping packets
Use this command to specify the number, in a range from 2-10, of packets a DHCP server sends to a pool address
as part of a ping operation. By default the number of packets sent to a pool address is 2, which is the smallest
allowed number when sending packets. Setting the number of packets to 0 disables this command.
4.8.17.1 no ip dhcp ping packets
This command prevents the server from pinging pool addresses and sets the number of packets to 0.
4.8.18 service dhcp
This command enables the DHCP server.
4.8.18.1 no service dhcp
This command disables the DHCP server.
Default none
Format ip dhcp excluded-address [highaddress]
Mode Global Config
Format no ip dhcp excluded-address [highaddress]
Mode Global Config
Default 2
Format ip dhcp ping packets <0,2-10>
Mode Global Config
Default 0
Format no ip dhcp ping packets
Mode Global Config
Default disabled
Format service dhcp
Mode Global Config
Format no service dhcp
Mode Global Config