Kontron AT8404 CLI - Manual (Page 323)

AT8404 Management Commands
Page 5 - 47 AT8404 CLI Reference Manual
5.12 Pre-login Banner and System Prompt Commands
This section describes the commands you use to configure the pre-login banner and the system prompt. The pre-
login banner is the text that displays before you login at the User: prompt.
5.12.1 copy (pre-login banner)
The copy command includes the option to upload or download the CLI Banner to or from the switch. You can specify
local URLs by using TFTP, Xmodem, Ymodem, or Zmodem.
5.12.2 set prompt
This command changes the name of the prompt. The length of name may be up to 64 alphanumeric characters.
5.13 Diagnostics Commands
5.13.1 diagnostics
This command will start diagnostics. If “interactive” is specified the switch will be restarted and the diagnostics
loaded. The user gets a menu to select interactively a scenario. A serial console is needed. Otherwise, if a scenario
is specified, this scenario is executed directly. You may start this scenario once or repeated for a time (timedloop),
for a number of repetitions (loop) or forever. The results are stored and can be displayed by using “show logging
diag-report”. Possible scenarios are “full” (all test purposes except the destructive ones), “quickturn” (scenarios
running fast) or “write” (destructive scenarios).
5.13.2 show logging diag-report
This command displays the results of the last diagnostic run. The diagnostic results file is created by a diagnostic
run..
5.14 PCI express Commands
5.14.1 show boardinfo pcie
This command displays the PCI Express clock settings.
Default none
Format copy //> nvram:clibanner
copy nvram:clibanner
//>
Mode Privileged EXEC
Format set prompt
Mode Privileged EXEC
Format diagnostics interactive
diagnostics {{timedloop | loop} <1-9999999> | forever}
Mode Priviledged EXEC
Format show logging diag-report
Mode Priviledged EXEC