Kontron AT8404 CLI - Manual (Page 132)

Switching Commands AT8404
AT8404 CLI Reference Manual Page 2 - 96
2.18.5 set igmp maxresponse
This command sets the IGMP Maximum Response time for the system, or on a particular interface or VLAN. The
Maximum Response time is the amount of time in seconds that a switch will wait after sending a query on an
interface because it did not receive a report for a particular group in that interface. This value must be less than the
IGMP Query Interval time value. The range is 1 to 25 seconds.
2.18.5.1 no set igmp maxresponse
This command sets the max response time (on the interface or VLAN) to the default value.
2.18.6 set igmp mcrtrexpiretime
This command sets the Multicast Router Present Expiration time. The time is set for the system, on a particular
interface or VLAN. This is the amount of time in seconds that a switch waits for a query to be received on an interface
before the interface is removed from the list of interfaces with multicast routers attached. The range is 0 to 3600
seconds. A value of 0 indicates an infinite time-out, i.e. no expiration.
Mode • Interface Config
• Global Config
Format no set igmp groupmembership-interval
Mode VLAN Config
Default 10 seconds
Format set igmp maxresponse <1-25>
Mode • Global Config
• Interface Config
Format set igmp maxresponse <1-25>
Mode VLAN Config
Format no set igmp maxresponse
Mode • Global Config
• Interface Config
Format no set igmp maxresponse
Mode VLAN Config
Default 0
Format set igmp mcrtrexpiretime <0-3600>
Mode • Global Config
• Interface Config
Format set igmp mcrtrexpiretime <0-3600>
Mode VLAN Config