Kontron AT8404 CLI - Manual (Page 139)

AT8404 Switching Commands
Page 2 - 103 AT8404 CLI Reference Manual
2.20.1 set mld
This command enables MLD Snooping on the system (Global Config Mode) or an Interface (Interface Config Mode).
This command also enables MLD Snooping on a particular VLAN and enables MLD Snooping on all interfaces
participating in a VLAN.
If an interface has MLD Snooping enabled and you enable this interface for routing or enlist it as a member of a port-
channel (LAG), MLD Snooping functionality is disabled on that interface. MLD Snooping functionality is re-enabled
if you disable routing or remove port channel (LAG) membership from an interface that has MLD Snooping enabled.
MLD Snooping supports the following activities:
• Validation of address version, payload length consistencies and discarding of the frame upon error.
• Maintenance of the forwarding table entries based on the MAC address versus the IPv6 address.
• Flooding of unregistered multicast data packets to all ports in the VLAN.
2.20.1.1 no set mld
Use this command to disable MLD Snooping on the system.
2.20.2 set mld interfacemode
Use this command to enable MLD Snooping on all interfaces. If an interface has MLD Snooping enabled and you
enable this interface for routing or enlist it as a member of a port-channel (LAG), MLD Snooping functionality is
disabled on that interface. MLD Snooping functionality is re-enabled if you disable routing or remove port-channel
(LAG) membership from an interface that has MLD Snooping enabled.
2.20.2.1 no set mld interfacemode
Use this command to disable MLD Snooping on all interfaces.
Default disabled
Format set mld
Mode • Global Config
• Interface Config
• VLAN Mode
Format set mld
Mode • Global Config
• Interface Config
• VLAN Mode
Default disabled
Format set mld interfacemode
Mode Global Config
Format no set mld interfacemode
Mode Global Config