Kontron AT8404 CLI - Manual (Page 137)

AT8404 Switching Commands
Page 2 - 101 AT8404 CLI Reference Manual
2.19.3 set igmp querier timer expiry
Use this command to set the IGMP Querier timer expiration period. It is the time period that the switch remains in
Non-Querier mode once it has discovered that there is a Multicast Querier in the network.
2.19.3.1 no set igmp querier timer expiry
Use this command to set the IGMP Querier timer expiration period to its default value.
2.19.4 set igmp querier version
Use this command to set the IGMP version of the query that the snooping switch is going to send periodically.
2.19.4.1 no set igmp querier version
Use this command to set the IGMP Querier version to its default value.
2.19.5 set igmp querier election participate
Use this command to enable the Snooping Querier to participate in the Querier Election process when it discovers
the presence of another Querier in the VLAN. When this mode is enabled, if the Snooping Querier finds that the
other Querier’s source address is better (less) than the Snooping Querier’s address, it stops sending periodic
queries. If the Snooping Querier wins the election, then it will continue sending periodic queries.
2.19.5.1 no set igmp querier election participate
Use this command to set the Snooping Querier not to participate in querier election but go into non-querier mode as
soon as it discovers the presence of another querier in the same VLAN.
Default 60 seconds
Format set igmp querier timer expiry <60-300>
Mode Global Config
Format no set igmp querier timer expiry
Mode Global Config
Default 1
Format set igmp querier version <1-2>
Mode Global Config
Format no set igmp querier version
Mode Global Config
Default disabled
Format set igmp querier election participate
Mode VLAN Config
Format no set igmp querier election participate
Mode VLAN Config