Kontron AT8404 CLI - Manual (Page 80)

Switching Commands AT8404
AT8404 CLI Reference Manual Page 2 - 44
2.11.8.1 no dot1x max-req
This command sets the maximum number of times the authenticator state machine on this port will transmit an
EAPOL EAP Request/Identity frame before timing out the supplicant.
2.11.9 dot1x max-users
Use this command to set the maximum number of clients supported on the port when MAC-based dot1x
authentication is enabled on the port. The maximum users supported per port is dependent on the product. The
value is in the range 1 - 16.
2.11.9.1 no dot1x max-users
This command resets the maximum number of clients allowed per port to its default value.
2.11.10 dot1x port-control
This command sets the authentication mode to use on the specified port. Select force-unauthorized to specify
that the authenticator PAE unconditionally sets the controlled port to unauthorized. Select force-authorized to
specify that the authenticator PAE unconditionally sets the controlled port to authorized. Select auto to specify that
the authenticator PAE sets the controlled port mode to reflect the outcome of the authentication exchanges between
the supplicant, authenticator and the authentication server.
2.11.10.1 no dot1x port-control
This command sets the 802.1x port control mode on the specified port to the default value.
2.11.11 dot1x port-control all
This command sets the authentication mode to use on all ports. Select force-unauthorized to specify that the
authenticator PAE unconditionally sets the controlled port to unauthorized. Select force-authorized to specify
that the authenticator PAE unconditionally sets the controlled port to authorized. Select auto to specify that the
Format no dot1x max-req
Mode Interface Config
Default 16
Format dot1x max-users
Mode Interface Config
Format no dot1x max-req
Mode Interface Config
Default auto
Format dot1x port-control {force-unauthorized | force-authorized | auto}
Mode Interface Config
Format no dot1x port-control
Mode Interface Config