Kontron AT8404 CLI - Manual (Page 312)

Management Commands AT8404
AT8404 CLI Reference Manual Page 5 - 36
5.9.8 radius server retransmit
This command configures the global parameter for the RADIUS client that specifies the number of transmissions of
the messages to be made before attempting the fall back server upon unsuccessful communication with the current
RADIUS authenticating server. When the maximum number of retries are exhausted for the RADIUS accounting
server and no response is received, the client does not communicate with any other server.
5.9.8.1 no radius server retransmit
The no version of this command sets the value of this global parameter to the default value.
5.9.9 radius server timeout
This command configures the global parameter for the RADIUS client that specifies the timeout value (in seconds)
after which a request must be retransmitted to the RADIUS server if no response is received. The timeout value is
an integer in the range of 1 to 30.
5.9.9.1 no radius server timeout
The no version of this command sets the timeout global parameter to the default value.
5.9.10 show radius
This command displays the values configured for the global parameters of the RADIUS client.
Default 4
Format radius server retransmit
Mode Global Config
Field Description
retries The maximum number of transmission attempts in the range of 1 to 15.
Format no radius server retransmit
Mode Global Config
Default 5
Format radius server timeout
Mode Global Config
Field Description
retries Maximum number of transmission attempts in the range <1-30>.
Format no radius server timeout
Mode Global Config
Format show radius