Kontron AT8404 CLI - Manual (Page 195)

AT8404 Quality of Service (QoS) Commands
Page 3 - 21 AT8404 CLI Reference Manual
3.4.11 policy-map rename
This command changes the name of a DiffServ policy. The is the name of an existing DiffServ
class. The parameter is a case-sensitive alphanumeric string from 1 to 31 characters uniquely
identifying the policy.
3.5 DiffServ Service Commands
Use the DiffServ service commands to assign a DiffServ traffic conditioning policy, which you specified by using the
policy commands, to an interface in the incoming direction
The service commands attach a defined policy to a directional interface. You can assign only one policy at any one
time to an interface in the inbound direction. DiffServ is not used in the outbound direction.
This set of commands consists of service addition/removal.
The CLI command root is service-policy.
3.5.1 service-policy
This command attaches a policy to an interface in the inbound direction. The parameter is the
name of an existing DiffServ policy. This command causes a service to create a reference to the policy.
3.5.1.1 no service-policy
This command detaches a policy from an interface in the inbound direction. The parameter is the
name of an existing DiffServ policy.
Format policy-map rename
Mode Global Config
Note: This command effectively enables DiffServ on an interface in the inbound direction. There is no
separate interface administrative 'mode' command for DiffServ.
Note: This command fails if any attributes within the policy definition exceed the capabilities of the
interface. Once a policy is successfully attached to an interface, any attempt to change the policy
definition, that would result in a violation of the interface capabilities, causes the policy change attempt
to fail.
Format service-policy in
Modes • Global Config
• Interface Config
Note: Each interface can have one policy attached.
Note: This command causes a service to remove its reference to the policy. This command effectively
disables DiffServ on an interface in the inbound direction. There is no separate interface administrative
'mode' command for DiffServ.