Kontron AT8404 CLI - Manual (Page 109)

AT8404 Switching Commands
Page 2 - 73 AT8404 CLI Reference Manual
2.13.32.1 no port-channel load-balance
This command reverts to the default load balancing configuration.
2.13.33 port-channel hash multicast
This command configures the multicast hash algorithm. The command allows the user to globally select the hash
algorithm used for distribution of NUC (Non Unicast) traffic. This includes broadcast and multicast traffic, as well as
unicast traffic to unknown destination MAC address (DLF, flooded). Traffic distribution may be based on Source
address (sa), destination address (da), or port number, or any combination thereof.
2.13.34 port-channel name
This command defines a name for the port-channel (LAG). The interface is a logical slot/port for a configured port-
channel, and is an alphanumeric string up to 15 characters.
2.13.35 port-channel system priority
Use this command to configure port-channel system priority. The valid range of is 0-65535.
2.13.35.1 no port-channel system priority
Use this command to configure the default port-channel system priority value.
2.13.36 show lacp actor
Use this command to display LACP actor attributes.
Format no port-channel load-balance { | }
Mode Interface Config
Global Config
Format port-channel hash multicast {sa|sa-port|da|da-port|port|sa-da|sa-da-
port}
Mode Global Config
Format port-channel name { | all | }
Mode Global Config
Default 0x8000
Format port-channel system priority <priority>
Mode Global Config
Format no port-channel system priority
Mode Global Config
Format show lacp actor {<slot/port>|all}
Mode Global Config