Kontron AT8404 CLI - Manual (Page 270)

Utility Commands AT8404
AT8404 CLI Reference Manual Page 4 - 56
The following parameters are displayed in the trace message:
4.11.14.1 no debug ping packet
This command disables tracing of ICMP echo requests and responses.
4.11.15 debug sflow packet
Use this command to enable sFlow debug packet trace.
4.11.15.1 no debug sflow packet
Use this command to disable sFlow debug packet trace.
4.11.16 debug spanning-tree bpdu
This command enables tracing of spanning tree BPDUs received and transmitted by the switch.
4.11.16.1 no debug spanning-tree bpdu
This command disables tracing of spanning tree BPDUs.
Parameter Definition
TX/RX TX refers to a packet transmitted by the device. RX refers to packets received by the device.
Intf The interface that the packet came in or went out on. Format used is unit/slot/port (internal
interface number). Unit is always shown as 1 for interfaces on a non-stacking device.
SRC_IP The source IP address in the IP header in the packet.
DEST_IP The destination IP address in the IP header in the packet.
Type Type determines whether or not the ICMP message is a REQUEST or a RESPONSE.
Format no debug ping packet
Mode Privileged EXEC
Default disabled
Format debug sflow packet
Mode Privileged EXEC
Format no debug sflow packet
Mode Privileged EXEC
Default disabled
Format debug spanning-tree bpdu
Mode Privileged EXEC
Format no debug spanning-tree bpdu
Mode Privileged EXEC