Kontron AT8404 CLI - Manual (Page 46)

Switching Commands AT8404
AT8404 CLI Reference Manual Page 2 - 10
2.2.8.1 no spanning-tree configuration revision
This command sets the Configuration Identifier Revision Level for use in identifying the configuration that this switch
is currently using to the default value.
2.2.9 spanning-tree edgeport
This command specifies that this port is an Edge Port within the common and internal spanning tree. This allows
this port to transition to Forwarding State without delay.
2.2.9.1 no spanning-tree edgeport
This command specifies that this port is not an Edge Port within the common and internal spanning tree.
2.2.10 spanning-tree forceversion
This command sets the Force Protocol Version parameter to a new value.
• Use 802.1d to specify that the switch transmits ST BPDUs rather than MST BPDUs (IEEE 802.1d functionality
supported).
• Use 802.1s to specify that the switch transmits MST BPDUs (IEEE 802.1s functionality supported).
• Use 802.1w to specify that the switch transmits RST BPDUs rather than MST BPDUs (IEEE 802.1w
functionality supported).
2.2.10.1 no spanning-tree forceversion
This command sets the Force Protocol Version parameter to the default value.
Mode Global Config
Format no spanning-tree configuration revision
Mode Global Config
Format spanning-tree edgeport
Mode Interface Config
Format no spanning-tree edgeport
Mode Interface Config
Default 802.1s
Format spanning-tree forceversion <802.1d | 802.1s | 802.1w>
Mode Global Config
Format no spanning-tree forceversion
Mode Global Config