Kontron AT8404 CLI - Manual (Page 343)

FASTPATH log messages AT8404
AT8404 CLI Reference Manual Page B - 10
Table 22: GARP/GVRP/GMRP Log Messages
Component Message Cause
GARP/GVRP/
GMRP garpSpanState, garpIfStateChange,
GarpIssueCmd, garpDot1sChangeCallBack,
garpApiCnfgrCommand,
garpLeaveAllTimerCallback,
garpTimerCallback: QUEUE SEND FAILURE:
The garpQueue is full, logs specifics of the
message content like internal interface
number, type of message etc.
GARP/GVRP/
GMRP GarpSendPDU: QUEUE SEND FAILURE The garpPduQueue is full, logs specific of the
GPDU, internal interface number, vlan id,
buffer handle etc.
GARP/GVRP/
GMRP garpMapIntfIsConfigurable,
gmrpMapIntfIsConfigurable: Error accessing
GARP/GMRP config data for interface %d in
garpMapIntfIsConfigurable.
A default configuration does not exist for this
interface. Typically a case when a new
interface is created and has no pre-
configuration.
GARP/GVRP/
GMRP garpTraceMsgQueueUsage: garpQueue
usage has exceeded fifty/eighty/ninety
percent
Traces the build up of message queue.
Helpful in determining the load on GARP.
GARP/GVRP/
GMRP gid_destroy_port: Error Removing port %d
registration for vlan-mac %d -
%02X:%02X:%02X:%02X:%02X:%02X
Mismatch between the gmd (gmrp database)
and MFDB.
GARP/GVRP/
GMRP gmd_create_entry: GMRP failure adding
MFDB entry: vlan %d and address %s
MFDB table is full.
Table 23: 802.3ad Log Messages
Component Message Cause
802.3ad dot3adReceiveMachine: received default
event %x
Received a LAG PDU and the RX state
machine is ignoring this LAGPDU
802.3ad dot3adNimEventCompletionCallback,
dot3adNimEventCreateCompletionCallback:
DOT3AD: notification failed for event(%d),
intf(%d), reason(%d)
The event sent to NIM was not completed
successfully
Table 24: FDB Log Message
Component Message Cause
FDB fdbSetAddressAgingTimeOut: Failure setting
fid %d address aging timeout to %d
Unable to set the age time in the hardware
Table 25: Double VLAN Tag Log Message
Component Message Cause
Double Vlan Tag dvlantagIntfIsConfigurable: Error accessing
dvlantag config data for interface %d
A default configuration does not exist for this
interface. Typically a case when a new
interface is created and has no pre-
configuration.