Rockwell Automation 592- E300 Overload Relay User Manual - Manual (Page 397)

Rockwell Automation Publication 193-UM015B-EN-P - June 2014 397
EtherNet/IP Information Appendix C
The following common services are implemented for the Analog Input Point
Object.
Table 394 - Analog Input Point Object Common Services
Analog Output Point Object — CLASS CODE 0x000B
Table 395 - Analog Output Point Object Class Attributes
4 Instances of the Analog Output Point Object are supported. The Value
Attribute can then be overwritten by DeviceLogix.
Table 396 - Analog Output Point Object Instances
All instances contains the following attributes.
Table 397 - Analog Output Point Object Instance Attributes
Service Code
Implemented for:
Service Name
Class Instance
0x0E Yes Yes Get_Attribute_Single
0x10 No Yes Set_Attribute_Single
Attribute ID Access Rule Name Data Type Value
1 Get Revision UINT 2
2 Get Max. Instance UINT 1
Instance Name Description
1 OutAnMod1Ch00 Analog Expansion Module 1 Output Channel 0
2 OutAnMod2Ch00 Analog Expansion Module 2 Output Channel 0
3 OutAnMod3Ch00 Analog Expansion Module 3 Output Channel 0
4 OutAnMod4Ch00 Analog Expansion Module 4 Output Channel 0
Attribute ID Access Rule Name Data Type Value
3 Get/Set Value INT Default = 0
8 Get Value Data Type USINT 0=INT
9 Get/Set Fault Action USINT
0=Hold Last State
1=Low Limit
2=High Limit
3=Zero
10 Get/Set Idle Action USINT
0=Hold Last State
1=Low Limit
2=High Limit
3=Zero
129 Get/Set Input Binding
STRUCT:
USINT
Array of USINT
Size of appendix I encoded path
Appendix I encoded path:
NULL path means attribute 3 drives the
output.
Otherwise, this is a path to a bit in the
Bit Table.
130 Get/Set Force Enable BOOL 0=Disable, 1=Enable
131 Get/Set Force Value INT Default = 0