Rockwell Automation 592- E300 Overload Relay User Manual - Manual (Page 311)

Rockwell Automation Publication 193-UM015B-EN-P - June 2014 311
Chapter
9
Firmware Updates
Introduction The purpose of this chapter is to provide detailed information regarding firmware
compatibility among the various E300 Electronic Overload Relay modules and to
provide instructions on how to upgrade firmware for an E300 Electronic
Overload Relay module.
Firmware Compatibility The sensing, control, and communication modules of an E300 Electronic
Overload Relay have their own firmware for the functionality of the module and
its subsystems. Each module and its associated subsystems can be upgraded using
the ControlFLASH utility which is the same utility used to download firmware
into a Logix based controller.
Table 338 shows the specific firmware revisions for
all E300 Electronic Overload Relay modules and subsystems for the three system
releases.
Table 338 - E300 Firmware Compatibility Table
Table 339 shows which firmware revisions are compatible with the other E300
Electronic Overload Relay modules and their associated subsystems.
Table 339 - E300 Firmware Compatibility Table
E300 System Revision 1.034 1.035 2.034
E300 Control Module
193-EIO Application 1.002 1.003 2.002
193-EIO Boot Code 1.005 1.005 1.006
E300 Communication Module
193-ECM-ETR Application 1.003 1.003 1.003
193-ECM-ETR Boot Code 2.001 2.001 2.001
193-ECM-ETR FPGA 1.008 1.008 1.008
193-ECM-ETR File System 1.001 1.001 1.001
E300 Sensing Module 193-ESM Sensing Module 1.001 1.001 2.002
E300 Control Module
193-EIO Application 1.002 1.003 2.002
193-EIO Boot Code 1.005 1.005 1.006
E300
Communication
Module
193-ECM-ETR Application 1.003 ✓ ✓ ✓
193-ECM-ETR Boot Code 2.001 ✓ ✓ ✓
193-ECM-ETR FPGA 1.008 ✓ ✓ ✓
193-ECM-ETR File System 1.001
✓ ✓ ✓
E300 Sensing
Module
193-ESM Sensing Module 1.001 ✓ ✓ ✓
193-ESM Sensing Module 2.002 — — ✓