Second, Invalid configuration parameter, Invalid configuration cause – Rockwell Automation 592- E300 Overload Relay User Manual User Manual
Page 237
Rockwell Automation Publication 193-UM015B-EN-P - June 2014
237
Metering and Diagnostics Chapter 7
Second
Second (Parameter 37) reports the second in the virtual real-time clock of the
E300 Electronic Overload Relay.
Table 242 - Second (Parameter 37)
Invalid Configuration Parameter
Invalid Configuration Parameter (Parameter 38) reports the parameter number
that is causing a configuration trip in the E300 Electronic Overload Relay. Refer
to
for more information regarding a configuration fault.
Table 243 - Invalid Configuration Parameter (Parameter 38)
Invalid Configuration Cause
Invalid Configuration Cause (Parameter 39) reports the reason for the
configuration trip in the E300 Electronic Overload Relay. Refer to
for
more information regarding a configuration fault.
Table 244 - Invalid Configuration Cause (Parameter 39)
Default Value
0
Minimum Value
0
Maximum Value
60
Parameter Type
UINT
Size (Bytes)
2
Scaling Factor
1
Units
Default Value
0
Minimum Value
0
Maximum Value
9999
Parameter Type
UINT
Size (Bytes)
2
Scaling Factor
1
Units
Default Value
0
Range
0 = No Error
1 = Value Over Maximum
2 = Value Under Minimum
3 = Illegal Value
4 = L3 Current Detected
5 = CopyCat Error
Parameter Type
USINT
Size (Bytes)
1
Scaling Factor
1
Units