Apple Motion 2 - Manual (Page 775)

Chapter 10 Using Filters 775
This filter can be used to simulate a bright light source in the picture.
Parameters in the Inspector
Center: Sets the position of the center of the lens flare.
Size: Sets the radius of the ring of the lens flare. Values range from 0 to 400.
Intensity: Sets the intensity of the lens flare. Values range from 0 to 4.
Falloff: Sets how fast the lens flare falls off. Values range from 0 to 10.
Color: Picks the color of the lens flare. Use the disclosure triangle to display Red, Green,
Blue, and Alpha sliders for more precise color selection.
Outer Color: Picks the outer color of the lens flare.
Ring Color: Picks the color of the ring of the lens flare.
Streak Color: Picks the color of the streaks in the lens flare.
Streak Intensity: Sets the intensity of the streaks. Values range from 0 to 1.
Streak Count: Sets the number of streaks in the lens flare. Values range from 1 to 100.
Streak Noise Frequency: Sets the frequency of the noise in the streaks. Values range
from 1 to 100.
Streak Noise Level: Sets the level of noise in the streaks of the lens flare. Values range
from 0 to 20.
Ring Radius: Sets the radius of the ring of the lens flare. Values range from 0 to 1.
Ring Width: Sets the ring’s width, with values ranging from 0 to 1.
Glow Falloff: Sets how fast the glow falls off of the lens flare. Values range from 0 to
20.
Original image Lens Flare applied
01112.book Page 775 Sunday, March 13, 2005 10:36 PM