Apple Motion 2 User Manual
Page 687
Chapter 9
Using the Replicator
687
The sequence goes through a full animation cycle starting at the original value of the
cells, moving to the value set in the Sequence Replicator, then returning to the original
value of the cells. This is similar to combining the To and From Sequencing options.
5
Choose All from the Unit Size pop-up menu.
The sequence animation affects all replicator elements simultaneously. The default is
Object, which applies the sequence animation to the elements of the replicator based
on the origin of the pattern.
6
Increase the Loops value to a minimum value of 3.
By default, a sequence animation plays through one time. The value of the Loops
parameter defines the number of times the animation repeats over the duration of the
replicator object.
7
Choose Ping Pong from the End Condition pop-up menu.
By default, the End Condition parameter is set to Hold, which completes a sequence
animation cycle, then starts the cycle again from the beginning. When set to Ping
Pong, the animation cycles forward one time, then cycles backward, then forward, and
so on.
Note: The End Condition parameter has no effect for Loop values less than or equal to 1.
For more information the Sequence Replicator parameters, see “
Unit Size set to All
Unit Size set to Object
01112.book Page 687 Sunday, March 13, 2005 10:36 PM