Apple Motion 2 - Manual (Page 655)

Chapter 9 Using the Replicator 655
The following images show the difference between the Clockwise and Counter
Clockwise parameters, using a replicator that applies a gradient over its pattern
elements.
Note: When the cell Color Mode is set to Over Pattern, a gradient is applied to the
elements over the replicator pattern. In this example, the gradient begins yellow,
becomes orange in the middle, and becomes red at its end.
When Build Style is set to Clockwise, the gradient is applied to the pattern in a
clockwise pattern. When set to Counter Clockwise, the gradient is applied in the reverse
direction.
Columns: Specifies the number of horizontal element points on a grid over the
selected replicator. In the case of an irregular shape (nonrectangular), points that fall
outside of the shape are ignored. This parameter is available when the Arrangement
parameter is set to Tile Fill.
Rows: Specifies the number of vertical element points on a grid over the selected
replicator. In the case of an irregular shape (nonrectangular), points that fall outside of
the shape are ignored. This parameter is available when the Arrangement parameter is
set to Tile Fill.
Gradient applied to replicator cells.
Build Style set to Clockwise Build Style set to Counter Clockwise
01112.book Page 655 Sunday, March 13, 2005 10:36 PM