Apple Motion 2 - Manual (Page 771)

Chapter 10 Using Filters 771
Parameters in the Inspector
Front: Sets the position of the center point of the front face of the object. Values are
coordinates.
Front Size: Sets the size of the front object, as a proportion of its original size. Values
range from 0 to 2.
Back: Sets the position of the center point of the back face of the object. Values are
coordinates.
Back Size: Sets the size of the back object, as a proportion of its original size. Values
range from 0 to 2.
Face Brightness: Sets a brightness level applied to the face of the object. Values range
from 0 to 2.
Front Brightness: Sets a brightness level applied to the front of the object. Values
range from 0 to 2.
Back Brightness: Sets a brightness level applied to the back of the object. Values range
from 0 to 2.
Side Method: Selects the method used to extrude the sides of the object. Shading or
Gradient can be selected.
Gradient: Selects a gradient preset to be applied to the object, or is used to edit a
custom gradient.
Dashboard controls
The Dashboard contains all of the same controls as the Inspector, with the exception of
the Gradient control.
01112.book Page 771 Sunday, March 13, 2005 10:36 PM