Apple Motion 2 User Manual
Page 739
Chapter 10
Using Filters
739
Parameters in the Inspector
Center: Sets the position of the center of the bulge.
Amount: Sets the amount of the bulge. Values range from 0 (no bulge) to 1000.
Scale: Sets the direction and scale of the bulge. Values range from –10 (the maximum
bulge inwards) to 10 (the maximum bulge outwards).
Dashboard controls
The Dashboard contains the Amount and Scale controls.
Bump Map
This filter uses a source object to define a bump pattern which can be used to deform
an object, with parameters to control the amount of distortion. You can use any image,
movie, or shape as the source object.
When this filter is initially applied, Bump Map behaves as if there were a black image
applied to the Map Image well, which does not distort the target image at all.
To learn how to add an object to the Map Image well, see “
Parameters in the Inspector
Map Image: An image well that displays a thumbnail of the map chosen.
Direction: Sets the angle at which the bump map protrudes.
Amount: Sets how far the bump map protrudes. Positive values push upward, negative
values push downward.
Repeat Edges: Sets whether or not the edges of the object are repeated.
Dashboard controls
The Dashboard contains the Map Image, Direction, and Amount controls.
01112.book Page 739 Sunday, March 13, 2005 10:36 PM