Apple Motion 2 - Manual (Page 730)

730 Chapter 10 Using Filters
Contrast
Adjusts the contrast of an object.
Parameters in the Inspector
Contrast: Sets the amount of contrast to be applied to the object. Values range from 0
(no contrast) to 1 (default contrast) to 2.00.
Pivot: Sets the center point of the contrast curve. Values range from 0 to 1.00.
Dashboard controls
The Dashboard contains the same controls as the Inspector.
Desaturate
Reduces the amount of color in an image by a specified amount. This filter can be used
to mute the color in an image, making brighter colors less saturated. It can also be used
to completely eliminate the color from an image, turning a color image to a grayscale
one.
Parameters in the Inspector
Desaturation: Sets the amount of desaturation. Values range from 0 (no change) to
1.00 (full desaturation).
Luminance Type: Sets how the luminance type is calculated. Values can be selected
from the following: NTSC, PAL, Film, Red, Green, and Blue. If NTSC, PAL, or Film is
selected, luminance is calculated based on weighting for those standards; if a channel
is selected, luminance is calculated using that channel.
Dashboard controls
The Dashboard contains the same controls as the Inspector.
01112.book Page 730 Sunday, March 13, 2005 10:36 PM