Apple Motion 2 - Manual (Page 738)

738 Chapter 10 Using Filters
Dashboard controls
The Dashboard contains the same controls as the Inspector.
Black Hole
This filter appears to suck an image into a center point as the value of the Amount
parameter increases. The top, bottom, and sides bow in as if being pulled inward.
Parameters in the Inspector
Center: Sets the position of the center of the black hole.
Amount: Sets the amount of force pulling on your object. Values range from 0 (no
gravity) to 1000 (the entire object is pulled into the black hole).
Dashboard controls
The Dashboard contains the Amount control.
Bulge
This filter appears to push an image outward, as if something were bulging it out from
behind.
Original image Black Hole applied
Original image Bulge applied
01112.book Page 738 Sunday, March 13, 2005 10:36 PM