Metrohm tiamo 2.3 (process analysis) - Manual (Page 988)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
972 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
5.6.4.6 MEAS Upol
5.6.4.6.1 MEAS Upol - Overview
Dialog window: Method ▶ MEAS Upol ▶ Properties... ▶ MEAS Upol - 'Command
name'
Command for amperometric measurements with selectable polariza-
tion voltage.
Instruments
This command can be executed with the following devices:
Titrando: 808, 809, 835, 836, 841, 851, 852, 857, 888, 890, 901, 904,
905, 906, 907
Titrino: 702, 716, 718, 719, 720, 721, 736, 751, 758, 785, 794, 798,
799
pH/Ion - Meter: 867
Robotic Titrosampler: 855
Appearance
The command has the following appearance:
Parameters
The parameters for the command MEAS Upol are configured on the fol-
lowing 4 tabs:
￭ General/Hardware
Parameters for devices, sensors and stirrers.
￭ Measuring parameters
Parameters for setting the measurement procedure.
￭ Evaluations
Defining further methods for evaluating measurement curves.
￭ Additional measured values
Defining further measured values which can be saved as additional col-
umns in the measuring point list.
Command variables
The following command variables are generated in the method run by the
command MEAS Upol and can be used in formulas under the designa-
tion 'Command name.Variable designation':