Metrohm tiamo 2.3 (process analysis) - Manual (Page 1015)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 999
Identifica-
tion Description
.IME Initial measured value (measured value before start
conditions are processed) in the unit of the measured
value
.LP.CAx Calculated value × (1...3) for the last measuring point
of the measuring point list
.LP.EXx External value × (1...3) for the last measuring point of
the measuring point list
.LP.GFL Gas flow value for the last measuring point of the
measuring point list in mL/min
.LP.MEA Measured value (temperature) for the last measuring
point of the measuring point list in the unit of the
measured value
.LP.TEM Temperature for the last measuring point of the meas-
uring point list in °C
.LP.TIM Time in s until the last measuring point of the measur-
ing point list is reached
.MA.MEA Maximum measured value (temperature) in the unit of
the measured value
.MA.TEM Temperature for the maximum measured value in °C
.MA.TIM Time in s until the maximum measured value is
reached
.MI.MEA Minimum measured value (temperature) in the unit of
the measured value
.MI.TEM Temperature with minimum measured value in °C
.MI.TIM Time for the minimum measured value in s
.MN.MEA Average of the measured value in the unit of the
measured value
.NMP Number of measuring points in the measuring point
list
.STY Type of stop with which the command was stopped: 1
= normal;0 = manual or after error