Metrohm tiamo 2.3 (process analysis) - Manual (Page 1642)

7.20 IO controller ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1626 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
Can be edited only for controlled variable = calculated value, other-
wise grayed-out and not available for editing.
Range -214783647.000 ... 214783647.000
Default value 0 or controlled variable setting, respectively
100% Mapping
Measured value to be used when the High level (100%) is applied as
input value.
Can be edited only for controlled variable = calculated value, other-
wise grayed-out and not available for editing.
Range -214783647.000 ... 214783647.000
Default value 100 or controlled variable setting, respec-
tively
Unit
Unit of the measured value to be used.
Can be edited only for controlled variable = calculated value, other-
wise grayed-out and not available for editing.
Input 50 characters
Default value % or controlled variable unit, respectively
Default value
Selection or input of the standard value which is to be used for the input if
the result is invalid.
Range 0% mapping of the input ... 100% mapping
of the input
Selection last value | setpoint value
Default value last value
Setpoint value
Setpoint value to which the control is to be set.
Range 0% mapping of the input ... 100% mapping
of the input 'Mapping unit of the input or of
the calculated value'
Default value 0% mapping of the input 'Mapping unit of
the input or of the calculated value'
Actuating variable
Selection of the actuating variable out of all of the analog outputs of the
Controller output type.
Selection 'Port description'