Metrohm tiamo 2.3 (process analysis) - Manual (Page 970)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
954 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
General/Hardware tab under Sensor to automatic or continuous,
then the temperature will be measured continuously.
Titrando, 855, 867
Range
-20.0 ... 150 °C
Default value 25.0 °C
Titrino
Range
-170.0 ... 500 °C
Default value 25.0 °C
5.6.4.4.4 MEAS U - Evaluations
Tab: Method ▶ MEAS U ▶ Properties... ▶ Evaluations
Command name
Name of the command.
Input 25 characters
The following additional methods for evaluation of measurement curves
can be activated and defined on this tab.
Fixed endpoint evaluation
Fix endpoint evaluation
on | off (Default value: off)
If this option is activated, then the associated values for the other meas-
ured quantities will be interpolated with a fix measured quantity (Meas-
ured value or Time) for the fix endpoint from the measuring point list.
Moves the selected line up (changes the sequence).
Moves the selected line down (changes the sequence).
[New]
Open the dialog window Fixed endpoint evaluation # to enter a new
fixed endpoint (see Chapter 5.6.4.4.6, page 958).
[Properties]
Open the dialog window Fixed endpoint evaluation # to edit the fixed
endpoint selected in the table (see Chapter 5.6.4.4.6, page 958).
[Delete]
Delete the selected line.