Metrohm tiamo 2.3 (process analysis) - Manual (Page 1520)

7.5 856 Conductivity Module ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1504 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
7.5 856 Conductivity Module
7.5.1 856 Conductivity Module - Overview
Dialog window: Configuration ▶ Devices ▶ [Edit] ▶ Properties… ▶ Properties - 'De-
vice type' - 'Device name'
The parameters for the 856 Conductivity Module are set on the follow-
ing tabs:
￭ General
General device information such as device name, device type, serial
number, etc.
￭ Measuring inputs
Properties of the measuring inputs.
￭ MSB #
Properties of the MSB connector 1...4 and the peripheral devices con-
nected to it.
￭ GLP
Information on GLP tests and GLP monitoring.
7.5.2 Properties - General
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ General
On the tab General, general properties of the device are displayed.
Device name
Designation of the device (can be freely defined by user).
Input 50 characters
Default value Device type number_#
Device type
Display of the device type.
Program version
Shows the program version of the device.
Only visible with devices that have their own firmware.
[Update]
Opens the dialog window Load new program version (see Chapter
7.1.6, page 1488).
This button is only displayed with devices that have their own firmware. It
is only active if the device has an old program version not supported by
tiamo and which can be updated by tiamo itself.