Metrohm tiamo 2.3 (process analysis) - Manual (Page 59)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 2 General program functions
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 43
Designation Description Commands
.HP{x}.MEA Measured value for the HNP x
(1…9) in mV (HNP = half neutrali-
zation potential) DET, MET
.HP{x}.TEM Temperature for the HNP x (1…9)
in °C DET, MET
.HP{x}.TIM Time in s until the HNP x (1…9) is
reached DET, MET
.HP{x}.VOL Volume for the HNP x (1…9) in
mL DET, MET
.IGF Initial gas flow (measured value at
the time of the start of the com-
mand) in mL/min MEAS T/Flow
.IME Initial measured value (measured
value before start conditions are
processed) in the unit of the
measured value DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without Ref,
Spec), CAL Cond,
CAL MEAS,
STDADD, DOS,
ELT MEAS
.ITE Initial temperature (temperature
before start conditions are pro-
cessed) in °C DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without T/Flow,
Ref, Spec), CAL
MEAS, STDADD,
DOS, ELT MEAS
.IVE Value of the input at the end of
the command. CONTROL
.IVS Value of the input at the start of
the command. CONTROL
.LCO Loop counter = current quantity
of completed runs, both of
Repeat loops and of While loops LOOP, CAL LOOP,
ELT LOOP
.LP.CAx Calculated value x (1…3) for the
last measuring point on the meas-
uring point list DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without Ref,
Spec, Opt), DOS