Metrohm tiamo 2.3 (process analysis) - Manual (Page 1622)

7.20 IO controller ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1606 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
Note
Each stepping motor has a port of the Type:
￭ Reference position
￭ Safety switch 1
￭ Safety switch 2
￭ Safety switch 3
The port information for these port types is automatically read out of
the stepping motor controller.
Assigned output
Selection of an output port assigned to an input port. The signal of the
output port depends on the signal of the input port.
Only active and editable for the port type level detector and leak detec-
tor.
Selection
All digital outputs
Note
Digital outputs of the Type = Alarm signal cannot be selected.
Signal
Select which value the signal on the output port should take.
Only active and editable for the port type level detector and leak detec-
tor.
Selection
Input signal | Inverted input signal
Default value Input signal
Signal processing
Delayed edge
The input signal will be registered on the ascending or descending edge.
Selection ascending | descending
Default value descending
Delay time
Delay time before registering the input signal on the ascending or
descending edge.