Metrohm tiamo 2.3 (process analysis) - Manual (Page 939)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 923
Additional external measured values
Additional external measured values
on | off (Default value: off)
If this option is enabled, then a maximum of 3 new measured values can
be taken over and saved from existing measuring commands (i.e. MEAS)
which can also be displayed in curves under the designation Extern 1…3
and used in formulas as variables 'Command name.EX1…3'-
[New]
Open the dialog window External measured value # in which the
parameters for the external measured value can be entered (see Chapter
5.6.3.11.2, page 929).
[Properties]
Open the dialog window External measured value # in which the
parameters for the external measured value can be edited (see Chapter
5.6.3.11.2, page 929).
[Delete]
Delete the external measured value selected in the table.
5.6.3.9.9 TET - Endpoint
Dialog window: Method ▶ TET ▶ Properties... ▶ Thermometric evalua-
tion ▶ [New]/[Properties] ▶ Endpoint
Reaction type
Selection of the reaction type according to which the curve is to be evalu-
ated.
Selection exothermic | endothermic
Default value exothermic
EP criterion
Criterion for the recognition of endpoints. Endpoints whose discovered
ERC value is smaller than the value entered here will not be recognized.
for reaction type = exothermic
Range
-999999 ... 0
Default value -5
for reaction type = endothermic
Range
0 ... 999999
Default value 5