Metrohm tiamo 2.3 (process analysis) - Manual (Page 1678)

8.4 Manual control - Functions ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1662 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
702, 716, 718, 719, 720, 721, 736, 794
Selection
Bit-pattern with exactly 8 characters (0, 1, *,
p) | ******** | Signal pattern
Default value ********
Spectrometer
Selection
Bit-pattern with exactly 10 characters (0, 1, *,
p) | ********** | Signal pattern
Default value **********
The output lines are numbered from right to left:
Output 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Bit 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Examples:
************1* sets the output line 1 to enabled (= set), which would
result in a stop command for a connected Titrino, for example.
************0* sets the line to inactive.
Note
We recommend masking the irrelevant output lines with an asterisk *
so as not to modify these line conditions.
Note
For Titrinos with 3 output lines, only 3 characters can be entered. If sig-
nal pattern is selected, also only the first 3 characters will be used.
[Set]
Set the bit pattern defined under Outputs.
8.4.4 Sample changer functions
8.4.4.1 Sample changer - Overview
Program part: Manual control
If in the subwindow for the device selection, a tower of a sample changer
is selected, then the functions and parameters belonging to this sample
changer are displayed in the subwindow Functions/Parameters.
Sample changer functions
The sample changer functions are displayed on the following tabs: