Metrohm tiamo 2.3 (process analysis) - Manual (Page 691)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 675
Designation Description
.SVT Total start volume (volume that was added in
dependence on all three start conditions) in mL
.TC.TC Temperature coefficient in %/°C
.TC.CO Coefficient c0 of the Chebyshev polynomial of the
solution used
.TC.C1 Coefficient c1 of the Chebyshev polynomial of the
solution used
.TC.C2 Coefficient c2 of the Chebyshev polynomial of the
solution used
.TC.C3 Coefficient c3 of the Chebyshev polynomial of the
solution used
.TC.C4 Coefficient c4 of the Chebyshev polynomial of the
solution used
.TC.MAX Maximum temperature coefficient in %/°C
.TC.MIN Minimum temperature coefficient in %/°C
.TC.TSTART Start temperature in °C
.TC.TSTOP Stop temperature in °C
5.6.3.3.6.2 MET Cond - General/Hardware
Tab: Method ▶ MET Cond ▶ Properties… ▶ General/Hardware
Command name
Name of the command.
Input 25 characters
The general parameters for the control device, the dosing device, the sen-
sor and the stirrer are defined on this tab.
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.