Metrohm tiamo 2.3 (process analysis) - Manual (Page 1267)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 1251
Appearance
The command has the following appearance:
Parameters
The parameters for the command CTRL are configured in the following
dialog window:
￭ 5.6.9.2.2CTRL - Properties
Command variables
The following command variables are generated in the method run by the
command CTRL and can be used in formulas under the designation
'Command name.Variable designation':
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
never been started
.FIN Command status; 1 = Command has ended at least
once, 0, invalid (variable not available) = Command
has never ended
5.6.9.2.2 CTRL - Properties
Dialog window: Method ▶ CTRL ▶ Properties... ▶ CTRL - 'Command name'
Command name
Name of the command.
Input 25 characters
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined