Metrohm tiamo 2.3 (process analysis) - Manual (Page 56)

2.4 Formula editor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
40 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
Designation Description Commands
.ENP Electrode zero point for the sensor
used for the command (dimen-
sionless for pH sensor or in mV for
the ISE sensor) and/or electrode
zero point calculated from the cal-
ibration (for STDADD and CAL
LOOP) DET pH, DET U,
MET pH, MET U,
SET pH, SET U,
STAT, MEAS pH,
MEAS U, MEAS T,
MEAS Conc,
STDADD, CAL
LOOP, DOS, ELT
LOOP
.EP{x}.CHA Charge for endpoint x (1…9) in
mA·s KFC, BRC
.EP{x}.DME Measured value differential for the
endpoint x (1…9) MET
.EP.DVT Drift for the endpoint x (1…9) in
µg/min KFC, BRC
.EP{x}.ERC ERC for the endpoint x (1…9) DET
.EP{x}.MEA Measured value for the endpoint x
(1…9) in the unit of the measured
value DET, MET, SET,
KFT, KFC, BRC
.EP{x}.MEP Quantity of endpoints in the win-
dow x (1…9); 1 = 1 endpoint, 2
= 2 or more endpoints, 3 = EP
corrected with Autodrift, 4 =
EP corrected with manual
drift DET, MET, SET,
KFT
.EP.QTY Measured value for the endpoint
in µg KFC, BRC
.EP{x}.TEM Temperature for the endpoint x
(1…9) in °C DET, MET, SET,
KFT, KFC, BRC
.EP{x}.TIM Time in s until the endpoint x (1…
9) is reached DET, MET, SET,
KFT, KFC, BRC
.EP{x}.VOL Volume for the endpoint x (1…9)
in mL DET, MET, SET,
KFT
.EPP Position after finishing the com-
mand. 0 = invalid position. PORT