Metrohm tiamo 2.3 (process analysis) - Manual (Page 60)

2.4 Formula editor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
44 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
Designation Description Commands
.LP.CHA Charge for the last measuring
point of the measuring point list
in mA s KFC, BRC
.LP.CNT Intensity of the last measuring
point on the measuring point list
in counts MEAS Opt, MEAS
Opt Conc, CAL
MEAS Opt
.LP.DME Measured value differential for the
last measuring point on the meas-
uring point list MET
.LP.DVT dV/dt for the last measuring point
on the measuring point list (SET,
KFT, STAT, DOS) or drift for the
last measuring point on the meas-
uring point list in µg/min (KFC,
BRC) SET, KFT, KFC,
BRC, STAT, DOS
.LP.ERC ERC for the last measuring point
in the measuring point list DET
.LP.EXx External value x (1…3) for the last
measuring point on the measuring
point list DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without Ref,
Spec, Opt), DOS
.LP.GFL Gas flow value for the last meas-
uring point on the measuring
point list in mL/min MEAS T/Flow
.LP.IGE Current pulsed current for the last
measuring point in the measuring
point list in mA KFC, BRC
.LP.MEA Measured value for the last meas-
uring point of the measuring
point list in the unit of the meas-
ured value DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without Ref,
Spec), CAL Cond,
CAL MEAS, DOS,
ELT MEAS
.LP.QTY Measured value (water) for the
last measuring point in the meas-
uring point list in µg KFC, BRC