Metrohm tiamo 2.3 (process analysis) - Manual (Page 1247)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 1231
Parameters
The parameters for the command RLS DEV are configured in the follow-
ing dialog window:
￭ RLS DEV - Properties
Command variables
The following command variables are generated in the method run by the
command RLS DEV and can be used in formulas under the designation
'Command name.Variable designation':
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
never been started
.FIN Command status; 1 = Command has ended at least
once, 0, invalid (variable not available) = Command
has never ended
5.6.7.10.2 RLS DEV - Properties
Dialog window Method ▶ RLS DEV ▶ Properties... ▶ RLS DEV - 'Command name''
Command name
Name of the command.
Input 25 characters
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.