Metrohm tiamo 2.3 (process analysis) - Manual (Page 688)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
672 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
Command variables
The following command variables are generated in the method run by the
command MET Cond and can be used in formulas under the designation
'Command name.Variable designation':
Designation Description
.BP{x}.DME Measured value differential for the break point ×
(1…9)
.BP{x}.MEA Measured value for the break point × (1…9) in the
unit of the measured value
.BP{x}.TEM Temperature for the break point × (1…9) in °C
.BP{x}.TIM Time for the break point × (1…9) in s
.BP{x}.VOL Volume for the break point × (1…9) in mL
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0
= READY; invalid (variable not available) = Com-
mand has never been started
.CLC Cell constant of the sensor used in the command
for conductivity measurement cells
.CONC Concentration of the solution used for the com-
mand
.CYL Cylinder volume of the exchange or dosing unit
used for the command
.DBL Total duration for the processing of the command
in s
.DSC Time for processing all start conditions in s
.EME End measured value (measured value after process-
ing of the command) in the unit of the measured
value
.EP{x}.DME Measured value differential for the endpoint × (1…
9)
.EP{x}.MEA Measured value for the endpoint × (1…9) in the
unit of the measured value
.EP{x}.MEP Quantity of endpoints in the window × (1…9); 1 =
1 endpoint, 2 = 2 or more endpoints, 3 = EP
corrected with Autodrift, 4 = EP corrected
with manual drift
.EP{x}.TEM Temperature for the endpoint × (1…9) in °C