Metrohm tiamo 2.3 (process analysis) - Manual (Page 1403)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Configuration
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 1387
Orientation
Selection
Portrait | Landscape
Default value Portrait
Portrait
Output of the device table in portrait format.
Landscape
Output of the device table in landscape format.
[OK]
The table of devices is shown in the required format as a PDF file and can
be opened directly with the Acrobat Reader; it can then be printed out
and/or saved.
6.5.3 Device properties
Dialog window: Configuration ▶ Devices ▶ [Edit] ▶ Properties… ▶ Properties - 'De-
vice type' - 'Device name'
With the menu item [Edit] ▶ Properties... in the subwindow Devices,
the properties window opens for the device selected in the device table in
which the parameters of the device can be edited. It consists of several
tabs. The tabs General and GLP are always present, the remaining tabs
depend on the selected device. Properties can be set for the following
devices:
￭ Titrando
￭ Titrino
￭ 756/831 Coulometer
￭ 712 Conductometer
￭ 856 Conductometer
￭ 867 pH Module
￭ 846 Dosing Interface
￭ 730 Sample Changer
￭ 774 Oven Sample Processor
￭ 778/789 Sample Processor
￭ 814/815 Sample Processor
￭ 855 Robotic Titroprocessor
￭ 864 Balance Sample Processor
￭ 874 Oven Sample Processor
￭ Avantes Spectrometer
￭ RS-232 device
￭ Balance
￭ Barcode reader
￭ IO controller
￭ Stepping Motor controller