Metrohm tiamo 2.3 (process analysis) - Manual (Page 256)

4.4 Templates ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
240 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
Inserting
In order to insert a fixed report in a report template the corresponding
symbol must be selected on the Module bar and then placed on the
report template by creating a field with the left mouse button.
Properties
X pos.
Shows the predefined x-position for the fixed report.
Y pos.
y-position within the permitted area.
Range 0.0000 ... (max. page height) mm
Width
Shows the predefined width of the fixed report.
Height
Height of fixed report.
Range 0.0000 ... (max. page height) mm
Fixed report
Selection of a predefined fixed report.
Selection Calculations | Electrode test data | Calibration
data | Curves | Messages | Measuring point list
| Method parameters | Result list | Raw data
(endpoints) | Standard addition | Statistics
data (short) | Statistics data (long) | Titration
and measuring parameters | Signature list
Determination | Signature list Method | Varia-
bles | Common variables used | Devices used |
Global variables used | Solutions used | Sam-
ple solution used (TC conductivity) | Sensors
used | Used colorimetric sensors | Monitoring
report
Default value Calculations
Command name
Entry of the command name for which a measuring point list is to be pro-
duced. With not defined, the lists for all curves present in the determina-
tion will be produced as default.