Metrohm tiamo 2.3 (process analysis) - Manual (Page 859)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 843
Designation Description
.EP.QTY Measured value (water) for the endpoint in µg
.EP.TEM Temperature for the endpoint 1 in °C
.EP.TIM Time in s until the endpoint is reached
.EQT End quantity after processing of the command) in µg
.ETE End temperature (temperature following processing of
the command) in °C
.FIN Command status; 1 = Command has ended at
least once, 0, invalid (variable not available) = Com-
mand has never ended
.FP{x}.DVT Drift for the fixed endpoint × (1…9) in µg/min
.FP{x}.MEA Measured value for the fixed endpoint × (1…9) in mV
.FP{x}.QTY Amount of bromine for the fixed endpoint x (1…9) in
µg
.FP{x}.TEM Temperature for the fixed endpoint x (1…9) in °C
.FP{x}.TIM Time in s until the fixed endpoint × (1…9) is reached
.IME Initial measured value (measured value before start
conditions are processed) in mV
.ITE Initial temperature (temperature before start conditions
are processed) in °C
.LP.CAx Calculated value × (1...3) for the last measuring point
on the measuring point list
.LP.CHA Charge for the last measuring point of the measuring
point list in mA s
.LP.DVT Drift for the last measuring point of the measuring
point list in µg/min
.LP.EXx External value × (1...3) for the last measuring point of
the measuring point list
.LP.IGE Current pulsed current for the last measuring point in
the measuring point list in mA
.LP.MEA Measured value for the last measuring point in the
measuring point list in mV
.LP.QTY Measured value (water) for the last measuring point in
the measuring point list in µg